Pro-drive shallow water outboard Bedienungshandbuch

OWNERS MANUAL www.prodriveoutboards.comPO Box 949 2702 Lake Dauterive Road Loreauville, LA 70552 PH#: 337-229-0034 FAX#: 337-229-2302 1PO

Running In Grass, Hydrilla & Lillies With Water Underneath.• While your boat is on step and running, no trim adjustment is needed. • Under extreme

Reverse Operating Procedure The concept is explained by comparing it to the same way a common ratchet and socket set in your tool set works. Below are

Step 2. Pull the reverse release pin down. Pull the tiller toward you slightly, then release the pin and continue pulling the tiller toward you unti

This picture shows the release lever lock for units with hydraulic power trim in the unlock position. Step 3. Once the unit is in reverse, lock the t

ImportantWhile in reverse in deep water, (anything over 10 inches), reverse gear should only be used at idle speeds. Full throttle in deep water cond

Unit Maintenance • Lower unit oil should be checked every 20 hours . Use only SAE 80W-90 or 75W-90 gear lubricant API service GL-5 (A synthetic gear o

PRO-DRIVE LOWER UNITS RECEIVED A MODIFICATION UPGRADE TO IT’S LUBRICATION SYSTEM. THE GEAR SYSTEM IS STILL FILLED WITH OIL, HOWEVER THE PROP SHAFT NEE

YOUR LOWER UNIT TOP BEARING IS LUBED BY GREASE AND NEEDS TO BE GREASED AT 15 TO 20 HOURS. THE GREASE FITTING IS LOCATED HERE. NOTE: 10 OR 12 PUMPS

grease into each. Reverse should be rotated and two shots of grease applied to grease port 1 and 2 every click of the reverse until the unit has been

Grease Tower Housing Pivot Pin (15 to 20 Hours) Salt Water Applications • After returning from trip wash complete unit with fresh water and allow to

Propeller Removal*Note: Do not engage the clutch to remove the prop. Doing so may damage the clutch and void clutch warranty. Always disconnect to b

To install the prop first coat the spline and thread with Locktite marine grade anti seize or equivalent and secure nut. Using your 1-1/8” wrench tigh

Trouble Shooting TipsPROBLEM SOLUTIONTILLER HANDLE TORQUE*Make sure you are trimmed correctly (SEE PAGE 7) *Make sure your weight distribution i

IMPORTANTWARRANTY INFORMATION*FOR MORE WARRANTY DETAILS PLEASE REFER TO YOUR LIMITED WARRANTY INFORMATION ON THE LAST PAGE OF YOUR OWNERS MANUAL. Pro-

Limited WarrantyIntroduction:Pro-Drive is the premiere manufacturer of shallow water outboards. Thank you for your purchase! Pro-Drive Outboards pro

24Customer Responsibility It is the customer’s responsibility to maintain the equipment in accordance with the instructions provided in the Owner’s Ma

Notes

TO THE OWNERThank you for purchasing a “Pro-Drive Shallow Water Outboard”. Your unit is designed for long life, dependability, ease of operation, safe

Safety Instructions IMPORTANTRead and understand these instructions. They are for your safety. Failure to follow these instructions may result in pro

Installation Instructions After installing your motor on the boat transom use the aluminum transom saver plate supplied with the unit, torque the boat

Unit Component and Control Feature Identification EngineControlBoxTwist Grip ThrottleTach / Hour MeterChoke Power Trim and Reverse Rocker Tiller Handl

Identifying the Controls and Control Box Reverse Switch Choke Switch Pull Out (Engaged) Push In (Disengage) Clutch Switch Push In (Neutral) Pull Out

START UP*Note: your engine is shipped without oil. Oil must be added before starting your engine. See the engine manual. (Check before adding oil. Do

Operation InstructionsRegular Operation• Make sure engine ignition is off. • Check engine oil. • Attach safety kill switch. (If electing to do so. Che